Electric Rates

Hot Tub Cost to Run: Per Month and Year

Hot tub cost to run: about 1,963 kWh a year for an electric heater and pump (EIA averages), or about $30 a month at 18.16¢ per kWh. Heating is most of it.

A white acrylic hot tub set into a light gray composite deck with steps down to a lawn, surrounded by hedges, potted topiary balls and a small pine in the foreground.
Photo by Hot Tubs of London on Unsplash

A typical electric hot tub uses about 1,963 kWh of electricity a year, based on Energy Information Administration (EIA) averages for 2020: 1,479 kWh for the heater and 484 kWh for the pump. At the U.S. average residential price of 18.16 cents per kWh for August 2026, that is about $356 a year, or about $30 a month. Where you live matters a lot: the same usage costs about two-thirds more at California’s average price ($584 a year) and more than 2.5 times as much in Hawaii ($926).

A hot tub is one of the larger electric loads a home can add, because it keeps hundreds of gallons of water hot around the clock. This guide shows the math, where the energy goes, how the cost changes by state and what lowers it. For the other big water-heating load in most homes, see our electric water heater cost to run guide.

The Formula

Cost = kWh used × your price per kWh

Your price per kWh is on your bill. If your bill splits supply and delivery, add the per-kWh parts together and leave out the fixed monthly customer charge. Our kW vs kWh explainer covers the units.

How Much Does It Cost to Run a Hot Tub?

EIA’s 2020 Residential Energy Consumption Survey (RECS) reports average electricity use per household that has each end use. Using those averages and EIA’s August 2026 U.S. average price of 18.16 cents per kWh (released October 23, 2026):

PartkWh a year (EIA, 2020)Cost a yearCost a month
Hot tub heater1,479$268.59$22.38
Hot tub pump484$87.89$7.32
Total1,963$356.48$29.71

Per day, 1,963 kWh is about 5.4 kWh, or about 98 cents.

Two cautions. EIA averages heaters and pumps separately over the homes that have each one, so adding them assumes a tub with both an electric heater and a pump. And these are 2020 averages across all climates and tub sizes. A big tub in Minnesota will use more than a small one in Arizona.

How much does a hot tub heater cost per hour?

A common heater size is 4 kW. For example, one 240-volt replacement element sold by Trevi is listed at “4.0KW /4000 watts” and 16.67 amps. Running for one hour, a 4 kW heater uses 4 kWh, which costs about 73 cents at 18.16 cents per kWh.

The heater does not run all day. It switches on to replace heat lost through the cover, shell and plumbing, and to reheat water after you use the tub. That is why the average heater uses 1,479 kWh a year rather than the 35,040 kWh a 4 kW element would use running nonstop.

How long does it take to heat a hot tub?

Water needs about 1 Btu per pound to rise 1°F (the definition of a Btu), and a gallon weighs about 8.34 pounds. Raising 400 gallons by 10°F takes about 33,400 Btu, or about 9.8 kWh. With a 4 kW heater that is about 2.4 hours of heating and about $1.78 at 18.16 cents per kWh, before any heat lost along the way (our calculation). A cold fill that must rise 50°F or more takes several times as long.

Hot Tub Cost by State

The same 1,963 kWh a year at each state’s average residential price for August 2026 (EIA, preliminary):

StatePrice (¢/kWh)Cost a yearCost a month
Nevada12.72$249.70$20.81
Louisiana12.87$252.64$21.05
Washington14.63$287.19$23.93
Florida14.99$294.25$24.52
Arizona15.05$295.43$24.62
Texas15.91$312.31$26.03
U.S. average18.16$356.48$29.71
California29.75$583.99$48.67
Massachusetts30.48$598.32$49.86
Hawaii47.18$926.14$77.18

August prices can differ from your yearly average, and a cold climate raises the kWh too. To use your own state’s price, see our electricity rates by state page.

What California’s Spa Rules Say About Standby Use

California regulates how much power a new portable electric spa may use in standby, that is, just holding its water temperature while no one is using it. For standard spas made on or after June 1, 2019, the California Energy Commission’s limit is 3.75 × V^(2/3) + 40 watts, where V is the fill volume in gallons, tested at a 37°F difference between water and air.

For a 400-gallon spa, that works out to about 244 watts on average. Over a year, that would be up to about 2,134 kWh, or about $387 at 18.16 cents per kWh (our calculation). That is a ceiling under test conditions, not a typical figure, and it does not include the energy to reheat water after use.

The rules also tie the result to the cover. The Energy Commission says a cover that “was not tested or tested but fails to meet the performance standard cannot be sold with the unit to the consumer.” Spas sold in California must carry a label that is “conspicuously displayed to the consumer,” so if you are shopping there, check that label.

How to Lower What a Hot Tub Costs

  • Keep the cover on and in good shape. California’s rules only let a spa be sold with a cover that was tested with it and passed, which shows how much the cover matters for holding heat in. A cover that is waterlogged or no longer seals lets the heater run more.
  • Lower the temperature when you will not use it for a while. The heater replaces heat lost to the air, and a smaller gap between water and air temperature means less loss.
  • Heat when power is cheapest. If you are on a time-of-use plan, setting the spa to heat outside peak hours can cut the cost per kWh. Our time-of-use rates and solar guide explains how those plans work.
  • Count it if you are sizing solar. About 2,000 kWh a year is a meaningful addition to a home’s usage. If you are getting solar quotes, make sure the installer’s usage estimate includes the hot tub, especially if you added it after the last 12 months of bills.

Who This Applies To

Electric hot tubs and portable spas. Tubs with gas heaters, in-ground spas heated by a pool heater, and wood-fired tubs use other fuels and are not covered by these figures. The cost figures use average prices; your bill may include fixed charges and taxes that do not change with usage.

Sources and verification

Important claimSourceStatus
1,479 kWh hot tub heater, 484 kWh hot tub pump, per household using the end use, 2020EIA RECS 2020, Table CE5.3bVerified
U.S. residential average 18.16 ¢/kWh, August 2026 (released Oct. 23, 2026)EIA Electricity Monthly UpdateVerified (preliminary)
State prices, August 2026EIA Electric Power Monthly, Table 5.6.AVerified (preliminary)
4 kW, 240 V, 16.67 A spa heater elementTrevi product pageQualified (one product)
Standby limit 3.75V^(2/3) + 40 W, spas made on or after June 1, 2019; ΔT 37°FCal. Code Regs. tit. 20, § 1605.3Verified
Cover and label requirementsCalifornia Energy Commission, portable electric spasVerified
Costs, heating time, standby ceilingOur calculations from the figures aboveVerified

Frequently asked questions

How much does it cost to run a hot tub per month?

About $30 a month for a typical electric hot tub, using EIA's 2020 average figures of 1,479 kWh a year for the heater and 484 kWh for the pump and the August 2026 U.S. average price of 18.16 cents per kWh. In high-price states such as California or Massachusetts it is closer to $49 or $50 a month.

How much does a hot tub add to an electric bill per year?

About $356 a year at the U.S. average price of 18.16 cents per kWh, based on 1,963 kWh a year. That figure adds EIA's 2020 averages for hot tub heaters and pumps; a large tub in a cold climate, or one kept very hot with the cover off, can use more.

How many kWh does a hot tub use?

EIA's 2020 survey found U.S. homes with an electric hot tub heater used an average of 1,479 kWh a year on it, and homes with a hot tub pump used 484 kWh on the pump. Added together, that is about 1,963 kWh a year, or roughly 5.4 kWh a day.

How much does it cost to run a 4 kW hot tub heater for an hour?

A 4 kW heater uses 4 kWh in an hour of running, about 73 cents at 18.16 cents per kWh. It cycles on and off to hold the temperature, so it does not run every hour.

Is it cheaper to leave a hot tub on or turn it off?

It depends on how often you use it. Holding temperature avoids long reheat waits for a tub you use regularly; raising 400 gallons by 10°F takes about 9.8 kWh (about $1.78 at 18.16 cents) before heat losses, by our math. For long breaks, lowering the set temperature or turning the heater off reduces the heat lost to the air.